Sonifex RB-MA2 Dual Microphone Amplifier

Sonifex RB-MA2 Dual Microphone Amplifier

3.488 DKK

The RB-MA2 consists of two independent low-noise microphone pre-amplifiers for converting mic level signals to line level
Model/Varenr.: SF-RB-MA2
Lagerstatus: Spørg venligst om leveringstid
Styk

Sonifex RB-MA2 Dual Microphone Amplifier

 

 

The Sonifex RB-MA2 consists of two independent low-noise microphone pre-amplifiers for converting mic level signals to line level, or for driving long lines from microphones to processing equipment.

 

All connections and controls are on the rear panel. The microphone inputs are XLR-3 type and are electronically balanced. The input gain for each input can be adjusted individually by a recessed pre-set potentiometer which allows for the use of both dynamic and powered microphones.

The XLR-3 line outputs are electronically balanced and can be wired unbalanced by grounding the non-phase signal, allowing you to feed both balanced and unbalanced equipment.

For each channel there are independent switches to control a high pass filter (low frequency roll-off at 125Hz) and to provide phantom power at +48V to the connected microphones.

 

 

 

RB-MA2 Diagram

RB-MA2 Block Diagram.

 

 

 

 

 

Technical Specification For RB-MA2

Audio Specification

Maximum Input Level: -10dBu
Maximum Output Level: +28dBu
Low Frequency Roll-Off: 125Hz @ 6dB/octave
E.I.N.: 130dB
Common Mode Rejection: >60dB typically
Frequency Response: 20Hz to 20kHz ±0.1dB (600Ω load, ref 1kHz)
Input Impedance: 2kΩ nominal balanced
Output Impedance: <50Ω
Gain Range: Adjustable 36dB to 75dB gain (each input)
Distortion: 0.01% THD @ 1kHz, ref +8dBu output
Phantom Power: 48V
   

Connections

Input: 2 x XLR 3 pin female (Balanced)
Output: 2 x XLR 3 pin male (Balanced, can be unbalanced)
Mains Input: Filtered IEC, switchable 110-120V, or 220-240V, fused, 6W max
Fuse Rating: Anti-surge fuse 100mA 20 x 5mm (230VAC)
Anti-surge fuse 250mA 20 x 5mm (115VAC)
   

Equipment Type

RB-MA2: Dual microphone amplifier
   

Physical Specification

Dimensions (Raw): 28cm (W) x 10.8cm (D) x 4.2cm (H) (1U)
11” (W) x 4.3” (D) x 1.7” (H) (1U)
Dimensions (Boxed): 36cm (W) x 20.5cm (D) x 6cm (H)
14.2” (W) x 8” (D) x 2.4” (H)
Weight: Nett: 1.00kg Gross: 1.45kg
Nett: 2.2lbs  Gross: 3.2lbs
Titel Type Størrelse Download
rb-ma1_2.pdf PDF 334.87KB Download

Produktets tags

Der er ingen tags registreret.

Mine tags