Tilbud
EuroCaster TX8000/3600V DAB+ Transmitter 5000W RMS + 2 Amplifiers

EuroCaster TX8000/3600V DAB+ Transmitter 5000W RMS + 2 Amplifiers

501.155,00 DKK 556.848,00 DKK

High-efficiency, 2 amplifiers, cabinet included (30U)

Model/Varenr.: EX-TX8000/3600V
Styk

EuroCaster´s Single channel AIR COOLED VHF Band III transmitter

TX8000/3600V  DAB+   High-efficiency, 2 amplifiers, cabinet included (30U)

 

Multiple amplifiers systems – Television Transmitters and Transposers

 

TX Series is EuroCaster´s High Power transmitter range, available in different versions with different output powers from 1500 to 20000 W rms (from 5000 to 24000 W p.s. when operating in analogue standards).

Equipment of the TX series are composed of some main subparts:

  • An exciter (dual driver as an option), with native adaptive pre-correction circuits, bringing multiple input interfaces (ASI, AET, EDI, IP, Satellite) and on-board GPS / GLONASS receiver for accurate synchronization in SFN environments;
  • Several amplifier stages (from 2 to 8 depending on the model and the output power level);
  • A control and monitoring unit, with embedded change over system 
  • An innovative and highly efficient Liquid cooling system.

 

TX  transmitters support several digital modulation standards (DVB-T/H/T2, ISDB-T/Tb, DAB/DAB+/T-DMB, ATSC), as well as dual-cast analog operation (supporting PAL and NTSC). TX obviously incorporates the innovative and distinctive engineering that has made the success of the low/medium power range of EuroCasters transmitters, allowing unparalleled ease of use and maintenance.

 

Main features:

  • Compact dimensions (single 19” Rack, including output filter)
  • Output Power up to 3600W rms (COFDM), up to 5000W rms (ATSC) or up to 8000W p.s. (analogue)
  • High efficiency broadband or wideband amplifier technology both in UHF and VHF bands
  • Single or Dual driver
  • Enhanced redundancy in Power Supply Units
  • DVB-T/H/T2, ISDB-T/Tb, DAB/DAB+/T-DMB, ATSC, PAL, NTSC, NICAM modulations fully supported
  • Embedded Re-Multiplexer/Layer Combiner/TS to BTS (188 to 204 byte) converter for ISDB-Tb
  • Adaptive pre-correction circuits
  • On-board high stability GPS / GLONASS receiver with battery
  • Flexible input interfaces (ASI/BTS/SMPTE-310M, ETI, EDI, IP, Satellite, analog audio and video)
  • control and monitoring unit with embedded change over and switching system

 

System

UHF digital output power: from 1500 W to 12000 W rms @ MER 38 dB typ. (DVB, ISDB)
from 2400 W to 17000 W rms (ATSC)
UHF analogue output power: from 5000 W to 24000 W p.s.
VHF digital output power: from 1600 W to 12000 W rms @ MER 37 dB typ. (DVB, ISDB)
from 1800 W to 14000 W rms @ MER 34 dB typ. (DAB/DAB+/T-DMB)
from 2500 W to 20000 W (ATSC)
VHF analogue output power: from 4600 W to 10000 W p.s.
Configurations: Single or dual driver
RF output connector: 7/8” (f) or 1-5/8” (f) or 3-1/8” (f) or 4-1/8” (f), EIA, 50 Ohm
(according to output power and frequency band)
Frequency agility: UHF Band IV and V or VHF Band III
Frequency resolution: 1 Hz
Precorrection: Adaptive
Exciter: (according to the model)
Integrated matrix circuits: ASI/BTS/Video (dual), audio and RF
BTS/ASI/Video matrix connectors: BNC (f), 75 Ohm
Audio matrix connectors: Tini-QG “Mini XLR”, 6 Pin (m), 600 Ohm

Modulator

DVB-T/-H/-T2

Standard: EN300744, EN302304, EN302755 V1.3.1 (DVB-T2-Lite), TS101191, TS102773 (T2-MI), TS102034
Inputs: 4x ASI BNC (f), 75 Ohm or 2x ASI BNC (f), 75 Ohm and 2x RJ45 TS oIP 10/100/1000
Seamless switch between any input
Hierarchical and not hierarchical (DVB-T)
FFT: 1K (DVB-T2), 2K, 4K, 8K, 8K ext. (DVB-T2), 16K & 16K ext. (DVB-T2), 32K & 32K ext. (DVB-T2)
Code rate: All modalities available according to the standard
Block Short or Normal (DVB-T2)
DVB-T: Reed-Solomon (204, 188)
DVB-T2: BCH, LDPC
Guard interval: 1/32, 1/16, 1/8, 1/4, 19/256 (DVB-T2), 19/128 (DVB-T2), 1/128 (DVB-T2)
Constellation: QPSK, 16QAM, 64QAM, 256QAM (DVB-T2). Rotated and non rotated (DVB-T2)
MISO processing: Supported

ISDB-Tb

Standard: ABNT NBR 15601, ABNT NBR 15603
Inputs: 4x ASI TS/BTS BNC (f), 75 Ohm or
2x ASI TS/BTS BNC (f), 75 Ohm and 2x RJ45 TS/BTS oIP 10/100/1000
Seamless switch between any input
FFT: Mode 1 (2K), Mode 2 (4K), Mode 3 (8K)
Code rate: 1/2, 2/3, 3/4, 5/6, 7/8
Guard interval: 1/4, 1/8, 1/16, 1/32
Hierarchical modulation: Up to 3 layers
Constellation: QPSK, 16QAM, 64QAM
Time interleaver: Fully supported
Partial reception: Supported

DAB/DAB+/T-DMB

Standard: EN 300401, ETS 300 799
Inputs: 4x ETI (NI[G703], NA5376[G704] or NA5592[G704]) BNC (f), 75 Ohm or
2x ETI BNC (f), 75 Ohm + 2x EDI (ETSI TS 102 693) RJ45 10/100/1000
Seamless switch between any input
Transmission modes: Mode I, II, III, IV (Automatically detected from the ETI stream, or user selectable)
Operation: MFN or SFN operations

ATSC

Standard: A/53, A/110
Inputs: 4x ASI / SMPTE-310M BNC (f), 75 Ohm or
2x ASI / SMPTE-310M BNC (f), 75 Ohm and 2x RJ45 TS oIP 10/100/1000
Seamless switch between any input
Modulation: 8-VSB
Input bit rate: 19.39 Mbit/s
Bandwidth: 6 MHz
Max processing delay: Up to 1 second (programmable)

Analogue

Standard: B, G, D, K, M, N, I
Inputs: Video BNC (f), 75 Ohm, audio Tini-QG “Mini XLR”, 6 Pin (m), 600 Ohm
Color system: PAL, NTSC
Integrated NICAM encoder: Available

Satellite Receiver

Standard: ETSI EN 300 421 (QPSK) (DVB-S)
ETSI EN 302 307 (QPSK, 8PSK, 16APSK) (DVB-S2)
ETSI EN 50083-9 (ASI)
ETSI EN 50221 (Common Interface)
DVB-S2: VCM, CCM, Multi Stream and Single Stream, Normal & Short FEC frames
Symbol rate: 1 – 45 Msym/s (DVB-S)
2 – 45 Msym/s (DVB-S2)
Constellation: QPSK, 8PSK, 16APSK
FEC: Automatic, all modalities available according to the standard
Block Short or Normal
DVB-S: Reed-Solomon (204,188)
DVB-S2: BCH, LDPC
Roll–Off: 0.2, 0.25, 0.35
Input connector: F (f), 75 Ohm
Frequency: L–band 930÷2250 MHz
LNB control voltage: Off, +13/18 Vdc, 22 kHz, 0.25 A (overload protection)
RF input level: 40 ÷ 100 db/µV (with attenuator)
Output connector: BNC (f), 75 Ohm
Modality: 188 bytes
Max input bit rate: 80 Mbps (CAM limit: 72 Mbps)
CAM interface: PCMCIA DVB-CI Common Interface
CA mode (Conditional Access): Multicrypt, Simulcrypt
CAS support: Mediaguard, Viaccess, Irdeto, Conax, BISS with Professional multiprogram CAM (descrambling of up to 24 Elementary Streams) Betacrypt, Cryptoworks, Nagravision with standard consumer CAM (descrambling of up to 4 services)

GPS / GLONASS

Input connector: N (f), 50 Ohm
Input/Monitor output 10 MHz: BNC (f), 75 Ohm
Input/Monitor output 1 PPS: BNC (f), 75 Ohm
Phase noise: -140 dBc/Hz @ 10 kHz
-150 dBc/Hz @ 100 kHz
Stability: 1e-12 / 24 H with disciplined OCXO
Hold-over stability: 5 μs after 5 hours (optional 1 μs after 24 hours)

Mechanical

Rack: See Ordering Info
(other configurations are available on request)
Width: 600 mm
Height: 1530 mm 
Depth: 1000 mm 
 
TFT touchscreen
Web GUI
SNMP
GPIO

Environmental

Operating temperature range: -5°C ÷ 45°C
Max. relative humidity: 90%, non condensing
Max. operating altitude: 2500 m. a.s.l. (>2500 m. optional)

Electrical

Power supply: Energy distribution system with different options:

 

  • Line 380-400 V3N~, 50/60Hz
  • Line 220 V3N~, 50/60Hz
  • Line 220-240 V~, 50/60 Hz
Efficiency: Up to 40% efficiency in digital (UHF models)

Notes

To comply with the applicable standards and limit values for the suppression of out-of-band emissions (and in the case of digital standards,
also for maintaining the required shoulder distance), the transmitter may only be operated with suitable filters at the RF output.

Specifications are subject to change without notice.

Produktets tags

Der er ingen tags registreret.

Mine tags